Has anyone been able to log their TCU with anything other than a single address A8 command?
I'm trying to log wheel speed sensors on my 2006 USDM STi (A2ZJE11J).
Here's the TCU's init string:
Code:
80 F0 18 39 FF A5 10 30 D0 2 11 31 00 01 00 00 00 00 00 00 00 00 04 13 00 80 00 00 00 00 00 00
When I send this I get a response:
Code:
80 18 F0 05 A8 00 00 01 3C + Checksum
But if I set the byte after A8 to 01 (respond until interrupted), I get no response. I also got no response when trying to send an A0 command (tried byte counts 00 01 02...).
