RomRaider

I noticed on the ignition table in MAP pressure only goes down to 4.35 while in the VE table goes down to 2.90, Can I add a column to the ignition table without bricking my ecu or would this even make a difference? I noticed on my VE table the 2.90 section is considerable higher values.

you wont be able to easily add a row or column to the table, but you can change all the axis values and rescale it to suit your setup if you like.

I know how to add the column but I just wonder if it would brick the ECU if I did add an extra column I know the ECU only has so much bandwidth

by adding a column do you mean expanding the size of the table though, in which case where are you expanding it too, its very likely the space your expanding into is already in use somewhere and remember you'll have to do it twice for map1 and map2 so you need to find 2x the space not in use.

It was just to expand the ignition table to give me more precise control over my spark at high boost. I can modify the map scaling but it just crams the values together.