RomRaider

I am trying to have a remote tune done on a 2010 WRX. I recently installed a EJ205 to replace the EJ255.

The tuner is asking for:
*AF Learning #1
*AF Correction #1
*AF Sensor #1
*Closed/Open Loop Status/Fueling
*Engine Load (g/rev)
*FKL - fine learned knock
*FBK - Feedback Knock
*Fueling Final
*Gear Position
*IAM - Ignition advanced multiplier (raw value)
*Ignition Total Timing
*Intake Air Temp *Injector Duty Cycle %
*MAF(v)
*Manifold Relative Pressure (PSI) 4-byte or Direct
*Manifold Absolute Pressure (PSI) Direct
*Primary Wastegate Duty Cycle (%)
*RPM
*Throttle Opening Angle %


I am having a problem with RomRaider Logging.. anytime I select these for logging, I get an error on the bottom left of the screen and nothing is recorded:

*Closed/Open Loop Status/Fueling
*FBK - Feedback Knock
*Gear Position


I updated RomRaider to the latest release. any feedback is appreciated.. Not sure what I am doing wrong.

has your tuner not offered to help setup your laptop for logging? You say you have the latest romraider but do you have the latest logger/ecu/car defs as well installed?

Also are you trying to select these items when connected to the car yeah? Doing it offline first then connecting to the car doesn't work out most times.

Are you using SSM on K-line or CAN?
If K-line, you may be hitting the packet size limit of the protocol, try just a few parameters first.
If CAN, does your tune have the CAN patch installed?