RomRaider

Just like the title states, i've seen a plenty of maps but I am new to open source, roast away but my stock injectors were failing before I could get with my tuner and was forced to install these injectors early along with the fuel pump. Any help or direction to go in would be very helpful!

If you can post your rom and some data logs that would be helpful.

i'd be curious firstly how your original injectors failed - just so you can be sure it wont happen again to the new ones.

but for dialling them in start with the latency values from the ID spreadsheet and scaling value around 900, run the car on a pull and monitor the AFR then adjust scaling from there until your back on target (assuming you were hitting targets before that is).

Once scaling/latency are dialled in then you can work on cold/hot start compensations to round it off. The fuel pump itself shouldn't need any tuning unless its of sufficient flow to outflow what your regulator can control.