DBW table converter (Outputs Throttle angle vs Pedal angle)

Kodename47 · **Joined:** Sun Jul 13, 2014 6:12 pm **Posts:** 111

Sorry guys, little low on spare time here. It's still on my to-do-list :wink:

Dr Waffles · **Joined:** Wed Oct 23, 2013 5:42 am **Posts:** 252

Not nearly good enough

Kodename47 · **Joined:** Sun Jul 13, 2014 6:12 pm **Posts:** 111

welaish wrote:

your sheert is great can you make it for any table size?

I can, what's the maximum size that is likely to be seen for any of the tables? I've built a sheet that re-scales axes so I could rip that straight out if wanted.

welaish · **Joined:** Tue Apr 29, 2014 12:48 am **Posts:** 946

Thanks!

Target throttle Plate Position: X=23 Y=16
Requested Torque: X=16 Y=17
Requested Torque Base (RPM): Y=16

Dr Waffles · **Joined:** Wed Oct 23, 2013 5:42 am **Posts:** 252

My Requested Torque to Throttle plate position is 27x21 (ReqxRPM)
My Pedal position to Requested Torque is 20x20 (APPxRPM)
No known 2D base table.

Dr Waffles · **Joined:** Wed Oct 23, 2013 5:42 am **Posts:** 252

Any progress amigo?

jon7009 · **Posted:** Sat Jun 29, 2019 5:20 am

I'm making one myself, now. I should be done in about an hour or so.

welaish · **Joined:** Tue Apr 29, 2014 12:48 am **Posts:** 946

jon7009 wrote:

I'm making one myself, now. I should be done in about an hour or so.

thanks a very long hour

(just Joking)

Dr Waffles · **Joined:** Wed Oct 23, 2013 5:42 am **Posts:** 252

Anybody end up finishing this? lol

RomRaider

Forum rules

DBW table converter (Outputs Throttle angle vs Pedal angle)

Who is online