I re-did the ID1300 14v range starting from .3ms (Because the minimum pulse width starts at .3ms)
It better follows the cuve at ultra low pw due to the increase in resolution; though I'm yet to nor have any idea how to interpolate that into the other voltage ranges
The values from there pretty much follow exactly the same path
Thoughts? Can anybody suggest a reason it'd be better to start compensating before the injectors minimum pulse width?
Also, suggestions on how to tweak the values based on voltage now? I know CB runs at 14v constant, but i'd still prefer to have it right.
Green RR values provided to us on page 1 of this thread
Blue = GM values
Red + "x" = updated values.Provided values for ID1300
