RomRaider

Can anyone point me the right direction, I'm running carberry and trying to setup flex fuel. I have Cobbs kit but am using ecuflash for tuning. I have the rear 02 logging my wideband, so I'm trying to use the two tgv signals for logging ethanol content and fuel pressure. I have the ff hooked up to the driver side tgv but when I set the ethanol content to the left tgv I get nothing from it but if I log the left tgv it'll show a reading. On the other hand the fuel pressure sensor is set to the passenger tgv and when I log the right tgv I get no signal but if I set the ethanol content to the right tgv I get a signal. I'm not sure what I could be doing wrong in using sdlogger 1.9 if that helps any input will be greatly appreciated

To use the cobb kit you have to switch your wideband over to one of the TGV since the cobb kit uses the tgv left plus the rear o2 for power and 5v signal. You wont be able to have a fuel pressure input unless you figure out a way to power the cobb flex kit from another source other than the rear o2.