RomRaider

not sure I understand the question ...

Hi and thank you.

Is it possible to port it for A2ZJ500F?

Groz

Starts, runs, drives. Tried enable lc lock mode with no luck. No effect

LC lock mode on fueling or timing or both ? Have you enabled fueling hacks and/or timing hacks (if not enabled lc lock or compensated does not work) ?
Have you tried changing maps via clutch+break+cruise up or down and adjusting LC rpm by cruise up/down when LC is active for example ?
(you have to transfer your tune - fueling/timing/boost tables - to merpmod specific tables in order to activate the fuel/timing/boost hacks safely)

Working now. Incredible! My bad. i did not have fueling and timing hack enabled. Cycles through intelligent 1, sport 1, sport sharp 1. Then intelligent 2, sport 2, sport sharp 2 in that order.

So i understand this correctly, i can use a ethenol content sensor to supply a tgv input 0-5v and then setup the blending from 0 - 1 raw value to suit?
Instead of blending injector scaling, we would use the 2 ve maps and other multipliers to fuel correctly on different blends?

good to hear it's working ...
I'll prepare another version those days that will be flexfuel ready (with injector scaling blending, VE table blending and everything else ...) -> this is a version to test if everything so far is working ...

I noticed after i switch maps, the lc is disabled thereafter, even after restarting the car

hmm, ok, let me investigate this

can you do a little test:
write a 100% oem rom on ecu, don't start the car (probably it won't start anyway) just leave contact on for a few seconds (for ecu to boot) then contact off and write the patched version again and test again

if still not working can you log
MerpMod LC Engaged Signal
MerpMod Launch Control RPM
Engine Speed
MerpMod FFS Engaged Signal
MerpMod FFS Speed Threshold
MerpMod FFS Mode
ThrottlePlate position
vehicle speed

Writing now... my logger definitions are missing all the merp stuff that was previously visible with my other rom.

in my zip file attached there are definitions for ecuflash and romraider ecu & logger

Man do I feel stupid - found them!

Flashed stock map/reds and waited awhile for ecu/flashed back =no change.

Logs attached.

ok, another version ... hopefully resolving the LC problem ...

Awesome!! I will have to test this tomorrow, is there any other functionality you want me to test?

no...there will be the flex version to test at first without flex fuel sensor ..