| RomRaider https://mailserver.romraider.com/forum/ |
|
| Newbie to Merpmod question https://mailserver.romraider.com/forum/viewtopic.php?f=37&t=18354 |
Page 1 of 1 |
| Author: | GeoNV [ Sun Apr 11, 2021 6:20 pm ] |
| Post subject: | Newbie to Merpmod question |
hey all, I've searched around a bit and I've still got a question. I found a patch for my ECU already (SharpTune.Resources.Mods.Gratis.AZ1G401V.MeRpMoD.Gratis.Testing.v13.5.7.1054.patch) patched my last rom in sharp tune and it said it was successful. I pointed ecuflash to the new definitions and it opened it successfully and fixed the check sums. What I'm curious about is- I don't want to run in SD mode yet- did it automatically convert me over to speed density? I want to use it initially for launch control and then slowly branch out. I've tuned a megasquirt computer in speed density before so I'm comfortable with the concepts and all, just want to basically start with my last working rom and slowly mod from there. I can't seem to find out where I am at now... Sorry if I've asked a stupid question! |
|
| Author: | solidxsnake [ Sun Apr 11, 2021 8:23 pm ] |
| Post subject: | Re: Newbie to Merpmod question |
There should be a table "Mass Airflow Mode" in the "MerpMod Control Panel" category that lets you decide how the ECU calculates load. |
|
| Author: | GeoNV [ Sun Apr 11, 2021 10:24 pm ] |
| Post subject: | Re: Newbie to Merpmod question |
Ah, thanks. I’ll clearly need to do some more reading! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|