I was looking for a table referred to as "Idle Airflow Min Target Decel Adder (RPM)" and wound up finding a table that appears to me to be this table, but it is 3D and appears to also include ECT. The logic in the function that cross references to the table address and location of the table, relative to other tables in the ROM, is also different from those I've encountered previously (those ROMs have all had a 2D table without ECT). There is, however, a table template in ECU flash for "Idle Airflow Min Target Decel Adder (RPMxECT)", so I think this ROM may just use a 3D table instead of 2D for this. Also a bit concerning was that the ECU Flash template shows 13 elements for ECT, whereas this ROM appears to only include 2 ECT elements (i.e. 50/60C, assuming I am correct that this is ECT). As I am a bit new to this, however, I was hoping that someone could double-check and confirm (especially since I'm doing this for another RR user and don't want to screw up his vehicle!).
Any help would be much appreciated. Thanks!
Screenshot and relevant information below:
USDM Market Vehicle
ECU ID 7412587007
Flash Method SUBARUCAN
Memory Model SH7058
Checksum subarudbw
32 Bit Rom
Entry Point is C0C
For 7058, Start is 0xFFFF0000, physical RAM length is 0xBFFF, but enter 0xFFFF.
Be sure to check the box to make the RAM segment.
Leave ROM length and start at defaults
Overrun Enrich RPM Delta Activation - CA8A4
Overrun Initial Injector Enrichment (IPW) - CA8A8
Overrun Fueling RPM Resume Thresholds - CA8F8
Overrun Fueling RPM Resume Threshold - Overrun Fueling = cd2a0 - DegreesF = caa14
Potential Tables of Interest
3D Table - Idle Airflow Min Target Decel Adder (RPMxECT) --- G/S - D5B60 --- RPM - D5B18 --- ECT? - D5B58
Attachment:
Idle Adder Table - '11 WRX.png
