 |
RomRaiderOpen Source ECU Tools |
|
RomRaider
Documentation
Community
Developers
|
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
zcivic
|
Post subject: Bench OBD2 Port  Posted: Sun Sep 01, 2024 10:18 pm |
|
 |
| Newbie |
Joined: Mon Feb 16, 2009 9:17 pm
Posts: 94
|
|
I’m hoping someone might be able to point me in the correct direction to find this info. Over the weekend I had to bench unbrick an 08 wrx ecu. EcuFlash went thru the whole procedure but I didn’t have the vehicle to read what was written to ecu. I’m wanting to make a bench setup just not sure if it’s just the 5 wires for the ECU: Power/ground/ssm/can hi/can low changing with each ecu. Then on the OBD side which wires/pins are they.
Thanks
Randy
|
|
| Top |
|
 |
|
V6er
|
Post subject: Re: Bench OBD2 Port Posted: Mon Sep 02, 2024 7:21 pm |
|
|
| Newbie |
Joined: Wed Oct 16, 2019 6:25 pm
Posts: 53
|
|
| Top |
|
|
|
zcivic
|
Post subject: Re: Bench OBD2 Port Posted: Tue Sep 03, 2024 6:16 pm |
|
|
| Newbie |
Joined: Mon Feb 16, 2009 9:17 pm
Posts: 94
|
|
Cool thank you. Pg 8 (I think) had the op2 diagram. So I can just see where factory wiring harness connects to the op2 and see what is there.
Thanks
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 8 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
