 |
RomRaiderOpen Source ECU Tools |
|
RomRaider
Documentation
Community
Developers
|
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
dkGoodrich dot com
|
Post subject: Bricked 07 wrx ecu? blue screen of death Posted: Tue Oct 05, 2010 5:25 am |
|
 |
| Newbie |
Joined: Wed Sep 29, 2010 5:16 am Posts: 17
|
|
Hi I was reflashing a 07 wrx with ecuflash and in the middle of it, it blue screened, gave me the driver error.
Now I can't connect to it with anything, open port, cobb, etc. Check engine light also does not flash when green service check connector is connected. Car is also dead in the water on my dyno.
I updated to the beta ecuflash afterwords but I guess it was too late because it did nothing either.
I was disabling the baro as it was showing a code if it matters?
Any advise, comments or suggestions would be very helpful.
Thanks for your time, Dk
|
|
| Top |
|
 |
|
Nuke209
|
Post subject: Re: Bricked 07 wrx ecu? blue screen of death Posted: Tue Oct 05, 2010 8:02 pm |
|
 |
| Experienced |
Joined: Mon Oct 16, 2006 1:10 am Posts: 195
|
|
If your pc ever gets a BSOD while flashing, don't turn off the car, reboot the pc and go back into ecuflash and it should connect and flash it over.
|
|
| Top |
|
 |
|
dkGoodrich dot com
|
Post subject: Re: Bricked 07 wrx ecu? blue screen of death Posted: Wed Oct 06, 2010 5:58 pm |
|
 |
| Newbie |
Joined: Wed Sep 29, 2010 5:16 am Posts: 17
|
|
Thank you for the response and tip! I will def be using it!
We are going to send off the ecu to tactrix for recovery.
Thanks for your time! DK
|
|
| Top |
|
 |
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 7 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|
|