RomRaider

Hi guys, i am new here i am learning all the goodies

My goal is to flash my ECU without paying a tons of money.
Im a software engineer so i know how bad it can end up if you mess with the wrong data.
But i still want to open the bin file and look up inside maybe play with it in Winosl or IDA

If anyone has a success story doing custom cable to read write those kind of ECU let me know, i still wonder how i will make a cable USB to ECU as i dont even know what type of plug the ecu takes ( im still totally new to ECU world )

But first if anyone has the stock bin file i would appreciate the share so i can see if i am able to reverse it first before i attempt anything else.

Thanks alot i hope to become a rom raider

I already reply to you.
Bye

Alright so i found this screenshot online:


And here i have the same table open in wols but i am trying to figure in the screenshot the values goes from 0 to 99 and from 500 to 14500.
However in wols i cant find any setting to change that, i assume it doesnt change much since its the same adress pointer after all.


Alright so after finding this, i am kinda lost as of how to find the rest, and do i need to find more to tune the fuel map ?
In the screen shot they have a Cyl1 and Cyl2 but both have the same values, however in wols i can only find this table once. so im confuse a little bit.

If anyone can give me a small hint that could keep me going i am willing to take

Thanks again!

Moderator: Commercial software images removed.

Hey I can help you!
Just write me down an email or pm