RomRaider

I tried to use the injector tab today, but pressing Record Data button didn't do anything even I changed the filter data and car was up to temp and moving.
Also tried the MAF tab and couldn't get it working either.

I've OP2, 0.8.2 dec04 loggger and metric en v370 defs. Data tab works, if I choose some parameters to log.
Com port dropdown list is empty, should it be? Bottom line on the logger says querying ecu and right corner shows some traffic SSM fast-k: *** queries / sec.

Any idea what could be the problem or what am I doing wrong?

I used MAF/injector tabs last summer with old logger version and vagcom succesfully.

The injector tab needs this parameters to work correctly.
COOLANT_TEMP = "P2";
ENGINE_SPEED = "P8";
INTAKE_AIR_TEMP = "P11";
MASS_AIR_FLOW = "P12";
MASS_AIR_FLOW_V = "P18";
AFR = "P58";
CL_OL_16 = "E3";
CL_OL_32 = "E33";
PULSE_WIDTH_16 = "E28";
PULSE_WIDTH_32 = "E60";
TIP_IN_THROTTLE_16 = "E23";
TIP_IN_THROTTLE_32 = "E54";
ENGINE_LOAD_16 = "E2";
ENGINE_LOAD_32 = "E32";

_16 or _32 are 16bit or 32bit ECU depending on what you have.
Can you log these in the Data tab?
Also, the Filter Data on the Injector tab has the units as defined on your Data logging tab. So if you log temperature in °F the Injector tab filter is also in °F.

If you have no COM port you must be use a J2534 cable.

Post the rr_system.log if you still have problems.
Or look in if for any lines such as: Logger data not found for id

Thanks for the fast reply. It was the user error as usual. I didn't have those parameters checked at all

You don't need to check any of them on the Data tab, just confirm they work there.
The injector tab will request the parameters when you click the Record button.