 |
RomRaiderOpen Source ECU Tools |
|
RomRaider
Documentation
Community
Developers
|
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Bimbap
|
Post subject: RomRaider question about validity of numbers in table  Posted: Sat May 17, 2025 6:44 am |
|
 |
| Newbie |
Joined: Sat May 17, 2025 5:55 am
Posts: 1
|
|
Hello,
Hoping someone could help me with reading the column and row numbers in the fuelling table. Both screenshots below.
Specs: ROM D2WD603H
Vehicle: Subaru Liberty 2005 3.0r Man
Basically when looking at the side row RPM numbers, it starts at 2 to 2 to 2 to 1800 to 2400 and so on
When looking at the top Engine Load row starts at 3.00 to 3.00 to 2.91 to 0.15 to 0.30 and so on
1.Why are first 3 numbers in both like that?
2. It's probably been asked before but can someone also help in scaling? it only is showing up to 5400rpm but it should be somewhere around 7000rpm.
In ECU flash if I adjust the scaling I can see the other numbers but the A/F ratio numbers are all over the place
Thank you
You do not have the required permissions to view the files attached to this post.
|
|
| Top |
|
 |
|
dschultz
|
Post subject: Re: RomRaider question about validity of numbers in table Posted: Fri Jun 13, 2025 8:22 pm |
|
|
| RomRaider Developer |
Joined: Wed May 20, 2009 9:49 pm
Posts: 7314
Location: Canada eh!
|
|
I would suspect a definition problem for that CAL ID.
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
