RomRaider

Hey everybody,
im new in Tuning and have some questions:

I have a BMW E36 320i 150 Hp 1998

I have partial read my Software with Siemens MS41 Flash Tool and changed some Parts With it.

Now i want to Flash my ecu and when i start , above the line is red and at least it says First 3 Checksumms Needs to be corrected , Write done ! Than i corrected them online !

Now i tries again to Flash and again the line above is red and says 0 Checksums needed correction Partial Write done ! Than i turned the ignition off for 10 seconds.

Than i read the car again and tested it in Rom Radier , but nothing there Changes inside. Than i compare it With my Software i uploaded nothing Changed and my Software is Tuned , but dont Upload in my car !

Whats wrong?


AND
My other question is , can you really damaged your E36 , if you have something do wrong in your bin?

Best regardd

you'll need to post up some screenshots to try and understand what your saying about the flash not flashing. make sure you've a full read backup incase you need it later.


and yes you can break your engine if you use bad values you in your tune.