Issue after flashing , EML/MIL/Traction lights.

e30v8 · **Joined:** Fri Sep 27, 2019 5:30 pm **Posts:** 3

Hi,

I've flashed a couple MS43 dme's using JMGarage using bootmode process, and also tried reflashing using Siemens tool. No errors during the flash, but when the DME is installed in the car I run into an issue where either check engine light is on, or EML or traction control light. Doing the same exact steps of flashing with 00056 logger ews off .bin with another MS43 sometimes works without these issues and sometimes doesn't. Does the MS43 index matter?

Is this an indication of a BAD dme? Or should I try maybe upgrade it's firmware using WinKPF and then reflashing again?

Thanks

mahdi93 · **Joined:** Fri Sep 13, 2019 7:44 pm **Posts:** 155

Same problem did you solve this issue ?

Grimmjar · **Joined:** Sun Jun 04, 2023 7:21 pm **Posts:** 4

I upgraded two MS43 to 00069 from 00037 and 00056 and no problems.
I have one with 00056 but didn´t test much.

RomRaider

Forum rules

Issue after flashing , EML/MIL/Traction lights.

Who is online