RomRaider

Hi everyone,

Is it possible to datalog a M54B30 Siemens MS45 equipped engine with Romraider?

Can't find any definition files for it. Are they in any way comparable to the MS43 ones?

Or are there any other tools to datalog MS45 ECU's?

testo works well for.

Hello, i have been wondering about a very similar question to the original post, mostly being a way to log certain data on the MS45, specifically the knock adaptation values, as i am trying to tune ignition timing and going off of those is a very effective way to do it. Any settings or programs that work? i tried the programs mentioned but could not find any that worked or had the proper definitions.

you need better searching...
bmw logger also did the job.

Ingnition for series engine very well in series for 98 octane fuel.

Could you be actually helpful instead of just insulting me for asking a very valid question? BMWlogger does not do the job, knock adaptation is not supported for MS45.

What is a series engine? and whats it very well at in series, this makes no sense.

https://github.com/ba114/Siemens-MS45.1

Tuner Pro ADX for logging that i just finished

For knocking use seperate tools...


A engine where you let you hands stay away from.

I faced an issue with ms45 quickflash logger from bimmertuningtools.
If logs RPM correctly, but other important stuff is nonsense, like load is "8671875" and constant "87" while accelerating.
Searching for alternatives, might update this thread later.