RomRaider

Hi I hoppe someone can helpme Im having communication problems with nisprog.

Already change the nisprog.ini parameters

Im using this cable: V14 Diagnostic Cable for VW Audi Skoda SEAT and Nissan, K+CAN OBD2 Code Reader Cable Compatible for VAG K+CAN Commander 1.4

This is my terminal output:

PS C:\nisprog> .\nisprog.exe
diag_os_gethrt() resolution <= 0us, avg ~0us
diag_os_getms() resolution: ~16ms.
Calibrating timing, this will take a few seconds...
Calibration done.

**************** nisprog v1.05-2523639 ****************
interface is now DUMB
Note concerning generic (dumb) interfaces : there are additional
options which can be set with "set dumbopts". By default
"K-line only" and "MAN_BREAK" are set.
nisprog: Type HELP for a list of commands
nisprog: Type SCAN to start ODBII Scan
nisprog: Then use MONITOR to monitor real-time data
nisprog: **** IMPORTANT : this is beta software ! Use at your own risk.
nisprog: **** Remember, "debug all -1" displays all debugging info.
running commands from file nisprog.ini...
port set to: \\.\COM5
dumbopts set to: 72
testerid: using 0xFC
destaddr: using 0x10
L1 debug is 0x8C: READ WRITE DATA
p3 set to 0 (0x0).
rxe set to 40 (0x28).
diag_l1.c:155: _send: len=5 P4=5 l0flags=0x1011; 0x81 0x10 0xFC 0x81 0x0E
diag_l1.c:252: _recv request len=1024, timeout=70;diag_l2_iso14230.c:766: Read/Write timeout.
diag_l2.c:435: Read/Write timeout.
L2 StartComms failed
now using 7058.
Must be connected normally (nc command) !
nisprog: Settings loaded from nisprog.ini

nisprog>