RomRaider

While writing on nisprog, the battery voltage dropped and the power went out.
I tried to start nisprog again, but an error occurred and I could not write.
Is there any solution?

Hello.
I am unable to connect to ecu because the power went out while I was writing.
Is it possible to use nisprog again for this?

I merged your cross-post from the nisprog thread.

what is going on in your .ini, why do I see a "please connect first", and then why are you calling guesskey. Although that is all probably irrelevant, most likely you have corrupt ROM and will need to unbrick viewtopic.php?f=65&t=12821