RomRaider

Hello, I have problem with reflashing 04 jdm wrx ecu (F2, 22611AJ800). As I read in how-to's I should connect 1-pin test connectors and 6-pin flash-memory connector(or 3-pin). I've done custom wiring(corresponds that scheme - http://subaru.tokers.ca/Impreza_1999-20 ... System.pdf) beacause I have swap in my car that ecu. All what I want to do with aftemarket flash-connectors it is connecting A10-B40(6) and A20-B40(8) (in corresponding with wiring scheme above - only A10 need to be switch directly). But when I do it on my car (A10-B40(6), A20-B40(8)) + test mode(A14 to ground) I hear blowers sequentially runs, in RomRaider logger test mode is value 1, but read/write mode is still 0.
What I do wrong?

p.s. logger works fine. And sorry for my english

if your getting test mode then it's just the flash block you need to sort out - should be a 4pin connector:


And you want to join pins 1/2 and pins 3/4 - not sure where they would show on your diagram though