RomRaider

Hi!

Does anyone have Subaru ECU with plastic case on table (or otherwise easy access), to measure accurate dimension of PCB, distance from top side of PCB to top inner side of plastic case and post good photo from bottom side of PCB? I need dimension to make new PCB to fit straight to plastic case.

Thanks!
Miika

I can do some measuring later in the evening...

But for now:




I think this is a Tribeca 3.0 ECU - it's the same PCB as the one in my Legacy 3.0 Spec.B, but with a little different component arrangement...

PCB dimensions are 154x121 mm, the distance between PCB and inner surface of the plastic case is 26 mm (the PCB slotted into the intended grooves).

Thanks!

Now I can get back to drawing board to get new pcb's that fits these also