RomRaider

Hello, I have some questions.
I want to log some parameters to understand why my afr is not good when idle (fail to the polution control lambda approximatively 1.05).
I have these parameters available
A/F Correction #1 (%) A/F Learning #1 (%) A/F Sensor #1 (Lambda) A/F Sensor #1 Current (mA) A/F Sensor #1 Heater Current (A) A/F Sensor #1 Resistance (ohm) Engine Load (Calculated) (g/rev) Engine Speed (rpm) Fuel Injector #1 Pulse Width (ms) Fuel Pump Duty (%) Ignition Total Timing (degrees) Manifold Relative Pressure (Corrected) (bar) Mass Airflow (g/s) Primary Wastegate Duty Cycle (%) Rear O2 Heater Voltage (V) Rear O2 Sensor (V) Throttle Opening Angle (%)

but not the misfire cyl 1-2-3 or 4, not the rear 02 sensor afr etc...

What can I do ? I remember that my ecu def was not find si I had to make a change in the file (romraider can now find my ecu A4RN100Q).

Thanks

you need to fix the misfire first, if you have a cylinder not working with poor spark then that cylinder blows unburned fuel into the exhaust giving a fake lean lambda reading as you have.