RomRaider

I would like to know if anyone can tell me the throttle control address for VQ35DET (AM90A).

0x79F0
0xa144

Thank you very much.
But both of these addresses are torque conversion maps, right?
Is this something I can change?

it's throttle

Thank you.
It's the same as this one.
If I change this, can I change the characteristics?

do this way

For anyone curious, just remember that there's quite a good reason that the throttle map isn't setup the way UpRev does it. The throttle map is meant to be able to accurately achieve the targeted torque values. In case anyone's curious, engine speed is used to modify for opening area. So lower torque values don't necessarily mean less throttle opening.

So seriously, don't mess with the throttle maps unless absolutely necessary. You won't beat Nissan's engineers without understanding the full extent of the ETC system.

This is true, the only thing I think that someone could do is map all needed parameters to discover at what load/rpm throttle does what exactly and build a spreadsheet based on that data. If they desire a certain angle or to reshape it they have corresponding torque values they can enter in to achieve a certain opening. However, the problem with this approach is that it assumes you know what and where the new optimal positions will be in a multifactorial system.