RomRaider

anyone else tried/tested this release (rev022)???

Thank you for the update... now that i have swapped out my stock ECU, this comes out. great timing for me, crap !!!

oh well, will try on the weekend when i have time....

thanks again tho....

Anything specific you'd like to have tested. I do my MAF tool testing on Thursday nights. I can do the Injector scaler logger that night as well.

Rev 22 working with LC-1 for me.

Still can't get the MAF tool working though (16bit)

Thanks for the efforts kascade.

Jeff

post up your romraider.log and romraider_stdout.log so I can have a look.

Thanks for the updates. My LM-1 isn't working. Logs attached.

MAF and INJ tabs return no logged data.. Here are romraider.log and romraider_stdout.log files

i've just uploaded a new revision (rev025) with some LM-1 changes and some extra debugging around the maf tab to try and sort out the 16bit ecu issues with it.

Please test both and post the generated romraider.log and romraider_stdout.log files.

I'll test the 16bit in a couple hours..

I'm still not reading my LM-1. Here are the logs.

Thanks for that. How old is your LM-1? I ask because I suspect it may be using v1 of the protocol which I haven't accounted for. So far I've only concentrated on v2, but will add support for v1 as well.

It would be great if someone with a fairly new LM-1 could test as well and post their logs.

I just wanted to post up that the MAF scaler seems to work now for me on 16-bit.

One thing that was apparently tripping me up were the default recording criteria. The IAT defaults are in C, but if your IAT is set to F in the "data" tab, F will be used on the MAF scaler. Since the range was 25-35 C by default, I wasn't getting any data (it's mid 50's F here right now). By changing the recording range to something more appropriate (40-100 F), the MAF scaler began working for me.

I have a recent LM-1 (purchased in November), I will try it out when I have an opportunity.

Thanks again for all of the hard work!!

Hmm I'll try that this evening..

I've probably had it for three years or so. It could be using the v1 protocol.

Is there much difference between the v1 and v2 protocols?

I wonder if there is some sort of ROM flash upgrade I can perfrom on the LM-1 that would convert it to the v2 protocol. I'll have to check on that too.

There are flashable firmware updates for the LC-1 and LM-1, but the newest release for the LM-1 is 2005, so there's a good chance you already have it.