RomRaider

Hi there guys,
i'm using the new 32bitbase file and the AZ1J500G def but still can't get timing tables and any AVCS table!!






I have two 32bitbase files, and old one and the new one posted here
http://www.romraider.com/forum/viewtopic.php?f=34&t=6704&start=0.
AFAIK i have to use the new 32BITBASE XML but If i use the old one i get these timing and openloop tables





but ecu seems to do nothing. I tried adding some fuel, no change, tried to get it go extremely rich and get no changes. With timing seems to happen the same.
Still have doubts with the open loop fueling. Which one takes effect under normal conditions? (no knock) KCA B or B???
What's wrong?

Regards.

There's only one 32BITBASE file and it is here.
Is your user level set appropriately to be able to modify those tables?

Yup, user level is set at developer and using the base you posted. Still no tables.

I'm confused.

What can be wrong? 32BITBASE is correct, user level is correct and the AZ1J500G xml is also correct.

Ok, solved the problem. I was using two 32bitbase files, an old one and a new one.
I had to use an old 32bitbase file for the AZ1G202G 2008 EDM STI cause with the one you posted here i didn't get any timing table.
BTW, why if the new 32bitbase is an upgraded file i dont get timing tables with the 08 sti file?

Here's the old base file i'm talking about. With that base i get every table for the 08 sti but with the new one i get none.
Regards.

You would be the only one? Nobody else appears to have had the issue?
would suspect it was using both at once