RomRaider

hello! first of all, i'm fairly new to using so i'm using romraider. i was going to temporarily force pass obd monitors for inspection. when i attempt to open the .bin file in romraider i'm getting an error.

ERROR - Data Mismatch
Table: Misfire CEL Fix
Table editing has been disabled.
Definition file or ROM image may be corrupt.

i have a couple questions:
1) is table editing only disabled on the one table or everything?
2) will i be able to check the force readiness option, flash the edited .bin and then go back to the original tune without any issues? or will there be a conflicting issue trying with software for reflash.

i tried to describe my situation to the best of my capability, and would like to say thanks in advance!! would hate to brick my ecu trying to flash corrupt software.

car is a:
02 wrx, sti block, atp3076r, 2000cc injectors, two aeromotive fuel pumps, etc, tuned on e85.

handled it. flashed fine, with no issues.
thanks.