RomRaider

for MS410 (?) its 5858 @ 00E2h, for MS411 its 6089 @ 017Ch

TS, and the result is?

Ill have results today

So I changed the value in the Bin and saved it then wrote the changed bin back to the ecu. After writing I re read it and the value changed back to the original value

Nevermind none of my writes are going through even though they say they are. Last time I flashed the ecu I was using the kwp2000 but now im using the vagcom with the ms41 flash tool. Its reading correctly but I guess not writing even though it goes all the way to 100% and says to turn the ignition off for 10 sec

Jump pin 14->18 of round connector. Iirc. May want to double check.

Im using a 20 pin to obd port connector

If i can read i should be able to write

No. You need to do what I said.

Thanks that worked. Also this is the correct factor for the ecu it fixed my rev limit in first and the ecu is seeing the correct speed.

E30 value:
1160

Do we know where, or if this same value exists in 41.1? I know it doesn't rely as much on VSS, but it would still be nice to correct.

D_munter posted it along with 410.

I tried to copy from the 41.2 section of the xml to the 41.1 24kb ID60, but it either gives me an error when I try to open a file, or just doesn't work.

This is what I'm trying to insert:


I'm sorry I need to be spoon fed, but I have no idea what I'm doing.

i need to add this to the defs.

41 - E2h, 59 - D8h, 60 - 17Ch

I think values for this calibration is different by default wheel size - for R15 wheels value is 6047, R16 is 6089, R17 is 6185.