RomRaider

Hello,

I've been trying to diagnose a Fuel Issue in my car, however I'm not able to see A/F Ranges.

I can see the value of AF Learning #1 in the logs, but not the ranges in Learning View.

It's showing "No data - A/F Extended parameter IDs not defined", might be a definition issue or something. (Using the most up to date ones already)

Screenshot attached below.

Best Regards,
Tom

Download your ROM and Open it in EcuFlash. Under the Patches heading, check the box to enable Subaru CAN Ram parameters. Save the ROM as a new name and then load it back to your Ecu. This will now permit additional logging parameters and I think may fix the Learning View.

Had a look through the logger definitions. They haven't been defined for your ROM at this time. Search the forums, someone may have already pulled them out.



Unfortunately this will not work. The required addresses need to be defined in the logger definitions and presently they are not.

appears the definitions are already included at least for ecuflash and the logger definitions as well. http://www.romraider.com/forum/viewtopi ... =34&t=7072

Yeah ECUFlash works fine.

Logging also works fine aside from A/F ranges in Learning View.

I can work around this just by cruising and logging MAF g/s and AF Learning #1 in different RPM ranges in order to log different g/sec ranges.

But well, having it on Learning View would be so much more convenient.

Already searched entire forums for those logger definitions which contains AF Extended Parameters, didn't find anything yet.

I might aswell open a definition request specific for those Parameters so we could add it to the definition. Maybe IDA guys could help me out with that haha.

Best regards,
Tom