RomRaider

HI!
I've spend 2 days on my ms42 (0110C6) trying to get fast rev in 328i e46 with no success ((
In limiters --> I've changed Softlimiter to be smaller than hardlimiter and hysteresis to 32 value and there was no effect
also tried to increase max rpm to 7K and car is reacting for this changes but still with soooooo slooooow REV that I can sleep.
Target is: Get only fast Revs at max rpm 6700-6800, with no popcorn, no shoots, no flames etc

other mods was disabling o2sensors, disa at higher rpms. no other maps changed.
The question is:
to get fast rev should I change values in deceleration (fuel cut) ? any ideas?


Edit!

I've already done it problem was that there is one map missing in definition file for c6 soft, found this and now it's cutting as hell

hi, i dont suppose you have stock c6 file for 328 do you, im after a partial to reflash my ecu with stock tune

Hi, can you post your files ? When I open up m52tub28 bin in C6 it doesn’t show all values, some of them are just “0” . Thx

[quote="Shpaq"]HI!
I've spend 2 days on my ms42 (0110C6) trying to get fast rev in 328i e46 with no success ((
In limiters --> I've changed Softlimiter to be smaller than hardlimiter and hysteresis to 32 value and there was no effect
also tried to increase max rpm to 7K and car is reacting for this changes but still with soooooo slooooow REV that I can sleep.
Target is: Get only fast Revs at max rpm 6700-6800, with no popcorn, no shoots, no flames etc

other mods was disabling o2sensors, disa at higher rpms. no other maps changed.
The question is:
to get fast rev should I change values in deceleration (fuel cut) ? any ideas?


Edit!

Hardlimiter should be lower than softlimiter