Hi all. After reading few posts about injector scaling, I came across few posts about subaru "mafless" mode, where you disconnect maf and ecu goes to kind of sd mode. So my question is: is it possible to scale injectors using this mod with aftermarket intake when you don't have the ability to install oem intake? Also I've read that latency depends on injectors mechanical part, fuel pressure and ecu drivers, so why do you need to increase latency for decapped injectors? You remove cap, which is a sort of restrictor, no adjustments to fuel pressure or valve part of injector.
kinda confused with this, as I have aftermarket intake which was scaled using stock injectors, but then I installed decapped light blue injectors instead of dark blue, and noticed that I scaled intake with dirty maf
fmic pipes do not allow installation of stock intake, so this problem has led me to think of another ways
