RomRaider

Good Afternoon,

I have been banging my head against a brick wall with my Tactrix and Romraider.

I am trying to run the Romraider and Logger software with my 2005 3.0 MT JDM Legacy.

I believe i have downloaded the ecu definition, however when i try to direct the logger to the definition location it does not show up. this is because it is a .HEX when the logger requires a .XML.

I have used ECflash to figure out what ecu i have D2WD610A and downloaded form the the official list as a .HEX

Any help or direction to where i can find out what all these files mean a do would be greatly appreciated.

Ive had a good dig through the forum but cannot find the differences between the HEX and XML.