RomRaider

Hey everyone, I am new to this whole tuning and logging thing but we are giving it a go. I have already been able to log and read through what has been logged and it has been really good so far. Except for a few things. I haven't been able to open up any of my roms that were made from ecuflash, in ram-raiders tuning. every time I have tried to open up my rom, or just the stock tune from my car it asks for the definition files, and then it says that it could not find one giving me the option of it choosing the first rom it sees, if someone is able to help me out with that, I would be very much appreciate it. there is one other thing however. Every time I have gone out to log my wrx, I cannot chose some parameter's that I would like to log. it will not let me do the more in depth things like read target boost, or even wastegate duty, knock, really the only things I have been logging is: Time Battery Voltage (V) A/F Sensor #1 (AFR) A/F Correction #1 (%) A/F Learning #1 (%) Fuel Consumption (Est.) (l/100km) Engine Speed (rpm) Intake VVT Advance Angle Right (degrees) Engine Load (Calculated) (g/rev) Engine Load (Relative) (%) IAM (multiplier) Ignition Total Timing (degrees) Manifold Relative Pressure (psi) Vehicle Speed (km/h) Atmospheric Pressure (psi) Accelerator Pedal Angle (%). When I try and select the parameter target boost for example, the connection status in the top right corner will keep switching from reading to connection and it goes back and fourth. and in the bottom left corner there is a error that pops up and flashes red then back to what it was. long story short, when I go to select some parameter's, ram-raider doesn't like what's going on and keeps connecting then reconnecting
Thank you for anyone who is able to help me out here,
Payton.