RomRaider

Today I f*** up my headgasget so I will spend some time on it in the garage I will post the numbers and connection.

These are the saab injectors I use

806 maf connection

Thanks for the photo!

But how is that working for you?

That's literally the MS41 MAF Pinout

Pin 1 - Ground - brown wire
Pin 2 - Yellow - Which goes on PIN 8 from ECU on MS41 - which is MAF ground
Pin 3 - White/Red - is +12v
Pin 4 - Black - goes to PIN 7 from ECU on MS41 - which is input signal from MAF

806 MAF Pinout and MSS50 wiring and pinout is the other way around

Pin 1 - Ground - brown wire
Pin 2 - Grey/Blue - Which goes on PIN 41 from ECU on MSS50 - which is input signal from MAF
Pin 3 - White/Red - is +12v
Pin 4 - Grey/White - goes to PIN 14 from ECU on MSS50 - which is MAF ground

Mhm... My maf position is not stock so I enlarge the cable, possible I switched the 2 cables in the wiring.

Hey there!

I see this is quite an old post but do you remember how you realized you maxed out the injectors? I'm currently making
215 whp on a similar build with the stock pink injectors with 240/240 cams, and i just got some reground cams so i'm
thinking of bigger injectors as well. Did you see the afrs get a bit high or upgraded for obvious safety?

Thanks in advance!