RomRaider

Hi Im try to instal new version of romraider v1.0 but dyno dont work, I try with READ FROM FILE and the image is attach.

If I use the same csv file on another laptop with romraider v0.5.9 it work.

I use it with ms41.2

I attach what I put on definition folder

Did you know if is possible solve?

Thanks

post up the log you used to create, also have you tried virtualDyno app? https://barnhill.bitbucket.io/

attach csv file.

Could you try this file on your romrider v1.0?

Ive try to use virtual dyno but doesnt work, attach error.

did you use virtual dyno with romraider csv file?

i think part of the problem is a lot of the apps are expecting CSV to be "Comma Separated Values" - but your PC is creating semicolon separated values and the comma is replacing the decimal point.

If you reformat your logs to use CSV you'll have better results with the likes of virtual dyno.

Also for virtual dyno it won't like that your column names start with "* " then the item name like "* Throttle Position (%)" - so just open with notepad and rename it TPS or "Throttle Position (%)" and same with RPM instead of having it as "* Engine Speed (RPM)" with the start and space, just rename it "RPM" and virtual dyno should pick it up.


Also if im doing a virtual dyno pull i'll be sure to log vehicle speed as well.

I dont know what your gear ratios are for whatever car it's from so here's a guess virtual dyno using a 2007-2011 120d N47 5th gear ratio:

ok that is greate. could you attach the file that you have load on virtual dyno?
did you use romraider dyno with v1.0 version?

sure - here you go. Didn't try with romraider I used this one in VirtualDyno, with the right values in place for car weight/specs the results should be the same though.