RomRaider

RomRaider 0.3.0 Beta is now available for download, with 32-bit ECU support, map comparing and CEL/checksum fixes. XML definition for these features is limited at the moment but merchgod is working on it.

http://www.romraider.com/forum/viewtopic.php?t=397

EDIT: removed file. Newest version in the ecu defs forum.

Cool, thanks for the help!

This one doesn't work all too well with 3.0b, a lot of the axis are borked. I used the private DBW one and it's working normal, however it's missing the 521N for the LGT.

I've finished up the 521N, but it wasn't done for that one. The addresses are spot on, so it has to be something different in 3.0b.

EDIT: I just checked A2ZJ500J with 3.0b and everything looks a-OK. Which revisions were you seeing problems? If it was one of the Legacy ones, I might have left in a half finished definition file for it when I uploaded it.

I'm almost done adding the Baja definition. I need to clean a few things up and then I can integrate into the 16-bit definition file.

I think it was a 510J file, i just overwrote it with the old one from the other thread and it was fine. I'm sure the updated one you'll post soon will fix it too.

Edit: It was a 2005 STi B10J.

I checked and the tables come up, but they're not working properly. For example, the rpm by the load in the tables are all mixed up. Thsi was using a A2ZJE11J rom.

Thanks for the work though.

Todd

P.S. Is the 2006 supported or no?

I must have accidently posted up an older incomplete version that I was working on - because everything works perfect when I run it, even for the revisions mentioned.

I'll be posting up the final release sometime tonight or tomorrow. Before I add any new definition file to the official thread, I always go through each new revision and make sure each table works properly.

I havent followed this thread very closely, but are you talking about a ECU def problem or might it be a bug in the new release? I'll look in to it if the code is the problem..

I don't think its a coding problem as it works perfectly for me. I have mutliple defs files at any one time, and I had intended to post an earlier DBW definition that I thought was finished up to its last revision, but I may have posted an even earlier one than that.

Regardless, I won't post up the latest release until it is 100% finished.

I just noticed that copying and pasting tables doesn't work on 3.0b (both CtrlC/V and also by using the Edit menu).

I reposted the correct version for the DBW file above. It is an older version, but newer than the one that is posted and it should be error-free for the most part.