RomRaider

LM-1/LC-1 testers needed for rev028!

Even if they work, I would advise against using this revision to tune fueling with. I will release a new version in the next day with some more bugfixes. The new release should also address a small issue with the AEM UEGO.

Thanks. Give the Injector tab a go too if you could

MAF scaler and LC-1 work 100% for me. I tried testing LM-1, but my cigarette adapter in my car is on the fritz.

I might have missed it, but can you post the official procedure you'd like us to go through for testing the injector tab?

it is basically the same as with the MAF tab, except there are two apply buttons for the injector scaler and latency offset.

was this tested using rev028?

Yes. The logs are from doing the posted MAF scaler procedure (with a 10 minute drive).

Rev 28 working for MAF scaling/LC-1 .... I'll test the injector tab tomorrow morning.

Jeff

I probably won't be able to test my LM-1 until tomorrow.

Ok, I tested rev028 on my way home. MAF tab works as before, on my 02WRX. It logs/plots/Interpolates.. But Give same error as before, when trying to apply changes to the MAF table.
My steps were:
1. Open RR
2. Load ROM
3. Opened MAF Scalar table
4. Selected ECU Logger
5. Selected MAF tab
6. Started recording data
7. Stopped Data logging
8. Interpolated
9. Selected Update MAF
10. Got Error that it couldn't find the MAF table, or whatever (same as before.)

Then I tried Injector tab

1. Selected Injector Tab
2. Recorded Data
3. Interpolated
4. Selected "Update Scaling"
5. Got error: Injector Flow Scaling Table Not Found (had Injector scaling table open)
6. Opened Injector Latency table
7. Selected "Update Latency"
8. It Applied the changes (-.56)

So
MAF table change applying did not work
Injector Scaling change applying did not work
Injector Latency Table changes DID apply.

bchslap, can you post up your rom, ecu_defs.xml and logger.xml that you are using and I'll have a look? If you are using the ecu_defs.xml and logger.xml that were packaged with the test release then let me know and just post/pm your rom.

Just letting everybody know the LM-1 plug-in worked.

NICE! Thanks for trying it out

LC-1 and Maf update worked with no errors on 02 A4SGE01C. One thing I had to do was lower the IAT from default 25-35 to 20-35. Is this bad form on my part? Should I wait until temps are warmer and within the default range to run the maf tab? Great job.

The injector tab collected data fine, I was able to update injector latency but was not able to update scaling

Here is the error:


It didn't even pop-up a confirmation box like it does with MAF and latency.

I have attached the logs if they'll be any help.

Let me know if you need anything else kascade.

Jeff