 |
RomRaiderOpen Source ECU Tools |
|
RomRaider
Documentation
Community
Developers
|
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
Subiestylez
|
Post subject: ECUExplorer problem  Posted: Thu Aug 10, 2006 11:42 pm |
|
 |
| Newbie |
Joined: Wed Aug 02, 2006 4:51 am
Posts: 9
|
|
Uber-nub questions but I need to know how to log this stuff, I have a 2005 wrx and I wanted to know how I can monitor my realtime numbers. When I open ECUExplorer it says my ECU is disconnected. I have my opensource cable connected and are in test mode (need to be in test mode?). I put the iginition in "ON" and it doesn't notice my ECU after much thinking and deliberation I start my car and its idleing rough due to test mode but it still doesn't recognize the ECU... Can someone help me out? Thanks
|
|
| Top |
|
 |
|
merchgod
|
Post subject: Posted: Thu Aug 10, 2006 11:53 pm |
|
|
| RomRaider Donator |
 |
Joined: Thu Mar 30, 2006 2:38 am
Posts: 5336
|
|
You don't need to be in diagnostics "test" mode to use Ecuexplorer. Most likely you have the com port set up wrong. In the lower left hand corner of the screen you should see the available com port. The one that says SSM diagnostics is the com port it is set to. Try the others ones by right clicking on one of them and selecting ssm diagnostics. Then restart ecuexplorer. Do this until you find one that works.
|
|
| Top |
|
|
|
Subiestylez
|
Post subject: Posted: Thu Aug 10, 2006 11:55 pm |
|
|
| Newbie |
Joined: Wed Aug 02, 2006 4:51 am
Posts: 9
|
|
| Top |
|
|
|
Subiestylez
|
Post subject: Posted: Fri Aug 11, 2006 3:31 am |
|
|
| Newbie |
Joined: Wed Aug 02, 2006 4:51 am
Posts: 9
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 1 guest |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
