Logger Road Dyno Car Definitions

B-BGTLimited · **Joined:** Thu May 20, 2010 11:59 am **Posts:** 62

Ok, I was just checking. So I should probably have 3414 for a weight in there to be a bit closer then.

dschultz · **Posted:** Fri Jun 04, 2010 7:15 pm

Version 8 had a syntax error in it, Version 9 is now the current file.

bswilmington · **Joined:** Thu Feb 11, 2010 12:55 am **Posts:** 24

sorry to ask but how do you get the car definitions into romraider?
it only allows you to add one definition file so do i some paste this into that file?

sorry not a newbie to romraider but this is bit more than i normally do
thanks

dschultz · **Posted:** Wed Jun 23, 2010 11:05 pm

I updated the original post.
When you download the file save it in the RomRaider installation directory.

phatron · **Posted:** Fri Jul 02, 2010 11:02 pm

is there nan easy way to get these into the airboy sheet?

wrxsti-l · **Posted:** Sat Jul 03, 2010 2:40 am

Not sure what I am doing wrong Dale, but I can't get the dyno/et bit to work.

This is my procedure:

set trip meter back to 0
get car ready for the 0-400m run
set the correct model and parameters on the dyno tab
click record and the green text prompting me to start is displayed
engage launch control and take off like a rocket
do well over 400m (as indicated on trip meter) before slowing down to a stop
check dyno tab graph and it always displays the same weird results

I saved the log thinking I could reload it, but it doesn't, so I can't post a screenshot, but the contents of the log is as follows:

Code:

02 ADM WRX STi 6MT(4), Elev: -473ft, Pres: 14.945psi, Hum: 60%, Temp: 84.2°F
60ft/18.3m:   0.000" @ 0.00 kph
330ft/100m:   0.000" @ 0.00 kph
1/2 track:   0.000" @ 0.00 kph
1,000ft/305m:   0.000" @ 0.00 kph
1/4 mile/402m:   0.000" @ 0.00 kph

Could the errors be because of the negative elevation? I'm actually at sea level, but pressure is a little high from the weather atm.

I'll try make it out for another 0-400m run later today and I'll take a screenshot of how it displays.

Leslie

dschultz · **Posted:** Sat Jul 03, 2010 6:50 pm

Elevation, temperature car type are not used in any of the ET results it is just informational content.

The ET calculator is only concerned with Vehicle Speed and Time. VS should be zero before you press the Record button. After that as long as you are moving and under 400m it will record your speed. Once it hits >400m it should stop logging and plot the results.

You could always delete your romraider.log file, set log4j.rootLogger=trace in the log4j.properties file rather than "info" and send me the log after you try it again.
Dale

HellTriX · **Joined:** Sat Sep 11, 2010 11:40 pm **Posts:** 20

Sweet to see this feature added.

Here are some defs for the 2011 That I made when using airboys spreadsheet.

Code:

<car>
<type>11 STi Sedan(3rd)</type>
<carmass>3470</carmass>
<dragcoeff>0.32</dragcoeff>
<rollcoeff>0.015</rollcoeff>
<frontalarea>22</frontalarea>
<gearratio>1.521</gearratio>
<gearratio1>3.636</gearratio1>
<gearratio2>2.235</gearratio2>
<gearratio3>1.521</gearratio3>
<gearratio4>1.137</gearratio4>
<gearratio5>0.971</gearratio5>
<gearratio6>0.756</gearratio6>
<finalratio>3.9</finalratio>
<transmission>manual</transmission>
<tirewidth>245</tirewidth>
<tireaspect>40</tireaspect>
<wheelsize>18</wheelsize>
</car>

<car>
<type>11 STi Sedan(4th)</type>
<carmass>3470</carmass>
<dragcoeff>0.32</dragcoeff>
<rollcoeff>0.015</rollcoeff>
<frontalarea>22</frontalarea>
<gearratio>1.137</gearratio>
<gearratio1>3.636</gearratio1>
<gearratio2>2.235</gearratio2>
<gearratio3>1.521</gearratio3>
<gearratio4>1.137</gearratio4>
<gearratio5>0.971</gearratio5>
<gearratio6>0.756</gearratio6>
<finalratio>3.9</finalratio>
<transmission>manual</transmission>
<tirewidth>245</tirewidth>
<tireaspect>40</tireaspect>
<wheelsize>18</wheelsize>
</car>

XNWRX · **Posted:** Mon Dec 13, 2010 9:02 pm

Are you sure of the final gear ratio on 2011 STi Sedan 6MT ?

Quote:

<car>
<type>11 E/USDM STi Sedan LTD 6MT</type>
<carmass>3384</carmass>
<finalratio>3.545</finalratio>
<rollcoeff>0.015</rollcoeff>
<dragcoeff>0.32</dragcoeff>
<frontalarea>22</frontalarea>
<transmission>manual</transmission>
<gearratio1>3.636</gearratio1>
<gearratio2>2.235</gearratio2>
<gearratio3>1.521</gearratio3>
<gearratio4>1.137</gearratio4>
<gearratio5>0.971</gearratio5>
<gearratio6>0.756</gearratio6>
<tirewidth>245</tirewidth>
<tireaspect>40</tireaspect>
<wheelsize>18</wheelsize>
</car>
<car>
<type>11 E/USDM STi Wagon 6MT</type>
<carmass>3373</carmass>
<finalratio>3.545</finalratio>
<rollcoeff>0.015</rollcoeff>
<dragcoeff>0.36</dragcoeff>
<frontalarea>22</frontalarea>
<transmission>manual</transmission>
<gearratio1>3.636</gearratio1>
<gearratio2>2.235</gearratio2>
<gearratio3>1.521</gearratio3>
<gearratio4>1.137</gearratio4>
<gearratio5>0.971</gearratio5>
<gearratio6>0.756</gearratio6>
<tirewidth>245</tirewidth>
<tireaspect>40</tireaspect>
<wheelsize>18</wheelsize>
</car>

I've checked twice on mine (EDM 2011 STi Sedan), I can confirm mine is 3.9

dschultz · **Posted:** Tue Dec 14, 2010 1:30 am

Oops, I fixed it.

sulk · **Joined:** Wed Oct 27, 2010 8:34 pm **Posts:** 3

Here's info for 05 USDM 2.5i Legacy Wagon.
Haven't had a time to test it out, but it looks like it should be correct. (Will test on thurs 16/12) Used information from other LGT, and stats for 2.5i from cars101.

Code:

    <car>
      <type>05 USDM 2.5i LEGACY WGN</type>
      <carmass>3300</carmass>
      <finalratio>4.111</finalratio>
      <rollcoeff>0.015</rollcoeff>
      <dragcoeff>0.31</dragcoeff>
      <frontalarea>22</frontalarea>
      <transmission>automatic</transmission>
      <gearratio1>2.75</gearratio1>
      <gearratio2>1.545</gearratio2>
      <gearratio3>1</gearratio3>
      <gearratio4>.694</gearratio4>
      <tirewidth>205</tirewidth>
      <tireaspect>55</tireaspect>
      <wheelsize>16</wheelsize>
   </car>

Let me know if anything looks to be off.

HellTriX · **Joined:** Sat Sep 11, 2010 11:40 pm **Posts:** 20

XNWRX wrote:

Are you sure of the final gear ratio on 2011 STi Sedan 6MT ?

I've checked twice on mine (EDM 2011 STi Sedan), I can confirm mine is 3.9

Your right, I was playing with stuff before hand and forgot to change values back to where they should have been. I have corrected the post.

legacydan · **Posted:** Thu Jan 27, 2011 12:01 am

hi guys this is the only info i can find for my jdm legacy, i cannot find info on the gear ratios

http://www.globalcar.com/datasheet/Subaru/2003_Subaru_Legacy_B4_2.0GT.htm

Can anyone add this for me?

im not sure how to use airboys spreadsheet

dschultz · **Posted:** Thu Jan 27, 2011 3:21 am

I think it's very close to the USDM 05 LGT. I added an entry to the def in the original post.

legacydan · **Posted:** Thu Jan 27, 2011 11:59 pm

Thanks, mine is actually a JDM import, not one of those inferior EDM's(joke!!) Thanks for adding it.

RomRaider

Forum rules

Logger Road Dyno Car Definitions

Who is online