RomRaider

Does anyone have the multiplier address for the 2010/11/12 STI? Similar to the one in this thread:
viewtopic.php?f=34&t=6557&start=18

Would be nice to be able to change the polarity of the multiplier so ignition advance can reduced in the higher gears.

Sure - AE5I910V:

Minimum RPM active above
ROM:000D1198 .float 1300.0
Minimum RPM disable below
ROM:000D119C .float 1200.0
Minimum load enable above
ROM:000D11A0 .float 1.0
Minimum load disable below
ROM:000D11A4 : .float 0.89999998
Multiplier
ROM:000D11A8 .float -0.12

AE5K500V - same sequence as above

ROM:000D2D68 : .float 1300.0

ROM:000D2D6C .float 1200.0

ROM:000D2D70 .float 1.0

ROM:000D2D74 .float 0.89999998

ROM:000D2D78 .float -0.12

AZ1G702I

ROM:000CFD28 .float 1300.0

ROM:000CFD2C .float 1200.0

ROM:000CFD30 .float 1.0

ROM:000CFD34 .float 0.89999998

ROM:000CFD38 .float -0.12

Thanks

I think for AE5K500V (2012 USDM) the address is D2D78, based on the relative location in the ROM.

Pleasure - I used your MAF tools so many times (when I was running MAF fueling!) I think it's only karmically correct

As a matter of interest - how much do you bump it up per gear? I've found you can give it quite a lot in 1st, 3~4*, tapering down to zero in 4th or 5th.

I don't add much to the low gears, 1.4* more in 1/2/3 then take it out in 4th/5th. My primary interest was to pull some timing in 5th/6th as well as lower wgdc and boost target in 5th gear.

Interesting - so even with a positive multiplier, the table can take negative values? or do you mean relative to the base timing - i.e. drop the whole table by the 1.4* that you're adding in 1st to 3rd?

BTW, working on pulling that H6 rom apart for you, in between work pressures!

Yeah, multiplier constant of 0.35 and then table value of 0 for 5th/6th, 2 for 4th, 4 for 3rd/3nd/1st. I also drop requested torque limit in 5th/6th to lower boost a little.

Thanks for looking at the H6 rom.