RomRaider

Hi there,

Dig the LV integration. One small anomaly - my air/fuel ranges all show "0.00 -- 0.01":



Anyone else get this?

Hi could i have the dropbox link, cant access assembla eithr

Cannot download, 500 server error. FF23.0.1 or IE9, makes no difference.

Here's a link to the Windows setup version.
http://db.tt/2PoN6J0L

I'll have a look at the ECU definition for that CAL ID to see if it's missing anything.
Even though the ranges are off the % correction should still be correct as they are reported by the Extended Logger parameters defined for the ECU.
Was this taken right after an ECU Reset?
Thanks.

The download site should be fixed. They say they only support IE version 8 and up, plus other non-IE browsers.
I confirmed with Seamonkey, IE8 and 10 that it works now.

Does it work with merchgod's LV application?
There is a "Known issue" with some early 32bit ROMs not allowing reading of some areas of the ROM via SSM. See "Known issues" in the original LV thread.
The only way around it is to implement an alternate read method such as read the ranges from the ROM file.

The LV function stopped working, do I just rr settings.xml?

Thanks for the new version! I've been unable to read/clear DTC's in my car via LV as the ECU was only recently defined, so I am hoping this update is the answer

I've just installed 0.5.7 and updated the logger definitions to 'logger_METRIC_EN_v178.xml' and have been able to connect to the ECU and log some parameters and open 'Read Diagnostic Codes' (there were none). However, when I try and open 'Learning Table Values', I get this error:



As you can see in the screen shot, my CAL ID is D2UJ001T and ECU ID is 4B5A347007.

Can you provide the rr_system.log please?

OK try this one. It may have some other stuff in it as I was trying a few things, but I think I hit the above error a couple of times in these logs. If not, I will get another one for you tonight with only that error in it.

OK I found the problem. In the code it didn't properly search the ECU def for the AF Learning Ranges table. This will be corrected in the next release candidate.

OK thanks very much for that

So should I still be able to read (and clear) DTC's via the 'Read Diagnostic Codes' (F8) menu item?

My car has had a random fault where it goes into limp mode every few months. I've never been able to read the error code with any of the available tools such as Learning View etc, as the ROM ID was not supported. So all I could do was reset the ECU, which fixed the problem temporarily so we could drive the car, but never gave me a clue as to where to start looking. I am hoping this new version of RomRaider will let me finally read the code and track the fault.

Yes that should be fine as it is purely an SSM read function and only relies on the logger XML file.

OK great. Well hopefully the car throws the error again soon so I can pull the code