 |
RomRaiderOpen Source ECU Tools |
|
RomRaider
Documentation
Community
Developers
|
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
mopar
|
Post subject: front oxygen sensor got my stumped  Posted: Tue Apr 14, 2015 12:00 am |
|
 |
| Newbie |
Joined: Mon Jun 20, 2011 1:35 am
Posts: 9
|
|
04 wrx,
p0031 front 02 sensor low input
tried another sensor that was good when i removed it.
Batt+ To heater ok.
ground from ecu works then starts to blink like its PWM and shuts off
afr reads for around 5 seconds and stops.
I tired solid ground to heater and disabled the p0031 dtc,
any input?
have new o2 sensor on way
|
|
| Top |
|
 |
|
bludgod
|
Post subject: Re: front oxygen sensor got my stumped Posted: Fri Apr 24, 2015 8:34 am |
|
|
| Moderator |
 |
Joined: Sat Jul 06, 2013 12:55 pm
Posts: 3297
Location: NI
|
|
could there be a short in the wires somewhere? the first few seconds will be the heater circuit getting up to temp so could be related.
Just because the sensor was working though doesn't always mean that when it's reinstalled it will still be working - if it got whomped by something during removal or when moving between cars or during installation its possible something has snuffed in it.
_________________
Good luck and may the logs be ever in your favour!
|
|
| Top |
|
|
|
mopar
|
Post subject: Re: front oxygen sensor got my stumped Posted: Sun Apr 26, 2015 5:29 pm |
|
|
| Newbie |
Joined: Mon Jun 20, 2011 1:35 am
Posts: 9
|
|
ecu had resistor broke off pcb
poor ground connections on the engine harness plugs behind battery.
ecu would fault out because of low heater current!
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 1 guest |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
