RomRaider

updated AZ1G101M-Flex.zip & AZ1G202G_FLEX.zip from my post above - made some changes regarding the CEL problem described by Sambo88

Sorry but it's a 500Kb Rom and there's not enough available free space for anything than the Gratis Version ...

But I'm thinking about a version with maximum 2 maps that can be done by reutilizing the oem maps (Base Timing A / B; target boost & WGDC maps MT/AT and Primary Open loop fueling A / B) ...

here you are

..UPDATED...

everywhere in the BoostHacks section requested torque is throttle plate angle for your rom ...
(didn't change the name in definitions and default values ...)

anything in the works for the legacy?

yep..currently on it

Would you happen to have anything for AE5F301C?

Cheers
Surge

I'll prepare something

But I must say again, you and all others using for the first time those builds are assuming some risks ...

Hi Andea,

Is this the latest update for the test? should I ignore the old file?

yes AZ1G202G_FLEX.zip

Ok great! its still confusing to me so if I am using three maps only should I make 1 and 2 the same, for each driving mode?

Intelligent SAME (1 and 2)
Sports SAME (1 and 2)
Sports# SAME (1 and 2)

correct?

no, with 3 maps only tables with 1 are needed
but for the start maybe it 's safer to make them all the same just for testing ...

Do you mean make all the 6 maps the same!? for testing?
or do you mean 1 and 2 are the same for each mode?

sorry for being stupid but its quiet confusing to me

welaish

the maps are in order:

1. Table 1 Intelligent
2. Table 1 Sport
3. Table 1 Sport Sharp
4. Table 2 Intelligent
5. Table 2 Sport
6. Table 2 Sport Sharp

if you choose 3 maps configuration the ECU will cycle through maps 1,2,3 so you will not use maps 4,5,6

in flex fuel config. you also have 3 maps but with blending between
Table 1 Intelligent and Table 2 Intelligent
Table 1 Sport and Table 2 Sport
Table 1 S# and Table 2 S#

in 6 maps config ecu can change between all 6

I was saying to make the same or better a safe tune on maps 4,5,6 just in case something goes wrong with map switching during test and ecu uses map 4 or 5 or 6 even if it should not ...

AZ1G900C version works well Only had time to test map switch with boost hacks. boost hacks is still new to me setting it up.
Only thing that didn't work afaik was launch control. Was this v2 like sambo88? I see he had the LC issue too.

Also i had an issue with RR logger def. Say if RR was pointing to another logger def then you can switch to the AZ1G900C.MeRpMoD.Switch.Testing.v00.60.d17.8.22.1631 which would work but if you close RR and reopen it wont even try and connect to the car. So basically i have to load in old logger def>close>reopen RR>Then select your def without closing RR

Edit: Should be able to test the logger def yourself once you load it in it says Error: java.lang.NullPointerException in red down the bottom. old defs no error.

Good to see testing goes forward
Yours was an older version regarding LC - attached the latest flex version - hopefully you won't have the DTC problem sambo88 had with an ealier version ...

Regarding logger : I see no errors when setting def in logger but it may happen if you have a profile saved in logger with several parameters already checked and open the logger with cable connected to the car -> if this is the case can you try uncheck selected parameters one by one to see which one is causing the error