RomRaider

Hey,

Successfully tuned my 2011 wrx however I'm running into some problems when trying to run the logger. After displaying the error the logger does open but I can't load definitions or change settings as the same error is displayed.

I have the definition in a folder on my desktop and i've installed/reinstalled x86 java etc. Not sure what the issue is.

Thanks in advance!

What Logger definition file are you trying to load?
The latest one is here: viewtopic.php?p=162644#p162644

Thanks dschultz,

the logger I'm attempting to use is TP_logger that was provided by the tuner. I can't upload the file as it is just over 2MiB in size.

I also put logger.dtd in the same folder with no success.

I may try the logger definitions you linked and see if they work.

Thanks

That would help confirm what issue you may have.
If you still have a problem with the official Logger definition, close the application delete the RomRaider settings.xml and try again.

Official logger definitions load up and I can tick boxes etc.

I've changed the communication settings to OBD CAN Bus.

Turned the car on and plugged the Tactrix in, connected USB and get the message 'Unable to send ECU init'

I also notice that the COM port is blank and there are no other options...

An Openport 2 does not have a COM port to select.

You should be using SSM CAN.

Is this an authentic Openport 2 cable? I don't see any info about its version, and after getting the CAL ID it seems to stop working with "error [8:ERR_DEVICE_NOT_CONNECTED], no devices available"

Try deleting the rr_system.log and settings.xml.
Start the logger select the official definition and set the Logging level to TRACE in Help > Debugging Level, switch to SSM CAN protocol and send a new rr_system.log if the problem persists.

deleted both rr_system.log and settings.xml, restarted everything and set everything back up again with the official definitions. Ensured that SSM CAN was selected and it seems to have connected!

Thanks for all your help dschultz

I tried the OBD connection on my ECU and found a bug after reading the ECU info initially.
So your "issue" uncovered a problem that needs fixing, thanks for finding it!

Your tuner should be able to provide better feedback with SSM logs over OBD.
Good Luck.